Model 2014iP

2014ip-grinder-pump-stationThe GP 2014iP grinder pump station consists of two pumps and a holding tank. The grinder pumps, motor controls and level-sensing are integrated into a compact unit, easily removable for service.


Solids are ground into fine particles that pass easily through the pump, check valve and small-diameter pipe lines — even objects that should not be in sewage, such as plastic, rubber, fiber, wood, etc. The 1 1/4" discharge connection can be adapted to any piping materials that meet local code requirements.

The tank is made from tough, corrosion-resistant, molded polyethylene and offers 1337 litres of capacity. The GP 2014ip can accommodate flows of up to 11,000 litres per day.

The grinder pump is automatically activated and, because it runs infrequently and for very short periods, its annual electric energy consumption is typically that of a 40 watt light bulb.

E/One grinder pumps do not require preventive maintenance. If service is required, the unique, one-piece core eliminates the need for in-field troubleshooting and servicing — the pump core can be quickly pulled out and replaced, meaning minimal maintenance costs and inconvenience for the homeowner.

Operational Information


1 Hp, 1,450 rpm, high torque, capacitor start, thermally protected, 240 volt, 50 Hz, single phase.

Discharge Connections:

1 1/4" BSP male thread
Can be connected to PE or uPVC pipe or any material required by local codes


.75 lps @ 0m TDH
.63 lps @ 20m TDH
.47 lps @ 42m TDH

Overload Capacity:

The maximum pressure that the pump can generate is limited by motor characteristics to a value well below the rating of the piping and appurtenances. Automatic reset feature does not require manual operation following overload.

US and foreign patents issued and pending.

*Discharge data includes loss through check valve which is minimal.


2014iP Drawings (PDF)

2014iP Installation Instructions (PDF)